9
light up, when the buttons (18, 19, 20) illumination
lights up, it means preheating is completed.
• Switch the water supply on by pressing the button
(19) « », the pump will switch on for 30 seconds
and hot water will be poured into the cup. After
switching the pump o, pour the water out from the
cup.Preheating is over.
MAKING ESPRESSO
ATTENTION! When making coee do not leave the
operating coee maker unattended, as it is necessary to
watch the cup being lled with ready coee!
AFTER PREHEATING:
• Make sure that the steam supply is closed. To do this
turn the knob (9) « » clockwise until bumping
«•».
• Remove the lter holder (5) by turning the handle (4)
to the left «INSERT» and remove the lter holder (5).
• Put ground coee in the small or large lter (6),
slightly tamp the ground coee with the back side of
the measuring spoon (16).
• Install the lter holder (5) into the coee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the lter holder
handle (4) to the right until bumping «LOCK».
• Wait until the buttons (18, 19, 20) illumination lights
up, the coee maker is ready for making coee.
• If you use a small lter (6), switch the water supply
on by pressing the button (18) « » to prepare one
cup of coee, the pump will switch on and work for 15
seconds, the pump operation time of 15 seconds is set
by default.
• To prepare two cups of coee, use a large lter (6) and
press the button (19) « », the pump will switch on
and work for 30 seconds, the pump operation time of 30
seconds is set by default.
Note: - watch the cup lling with the ready coee, if you
need t switch the water supply o, press again the button
(18) « » or the button (19) « ».
• Switch the espresso machine o by pressing the on/
o button (17) « », the buttons (17, 18, 19, 20)
illumination will go out.
• Wait until the coee maker cools down and remove
the lter holder (5) by turning the handle (4) to the left
«INSERT». Remove the ground coee remnants and
wash the lter (6).
• For easy removing of the coee remnants use the
retainer on the handle (4) to prevent the lter (6) from
falling o the holder (5).
• Notes:
-the cups should be preliminary heated up, when
water heats up in the boiler, put the cups on the tray
(8).
- if you need to promptly remove the lter holder (5),
you have to reduce the pressure in the boiler, switch
the coee maker o by pressing the on/o button
(17) « », place a suitable cup under the tip
(11) and slightly open the steam supply by turning
the knob (9) « » counterclockwise. After the