20
Example: Fixed program for soup
Put on the lid and rotate it clockwise as far as it will go. Close the valve.
Plug into the power supply – 8 lines light up on the display.
Press the soup button – 0,7 bar appears on the top display; “25 minutes pressure
cooking time” flashes in the bottom display.
The start/stop button must be pressed within 30 seconds, otherwise the device will
switch back to standby mode. The pressure cooking time starts counting when steam
pressure has built up with the valve closed. The display shows 0.7 bar as well as the
running cooking time. After the time has expired the device automatically adjusts
itself to “warming”. The display shows 4 hours as well as the temperature in the pot.
Example: Soup self-programming
The fixed cooking time could too long/too short or the
quality of the food may be too delicate, meaning that only 0.3 bar is required.
Press soup button
once, 0.7 bar appears in the display, 30 Min flashes. Select time
of 1-35 Min. using the
button. Press the Soup button again and change the
steam pressure from 0.7 bar to 0.3 bar. Start selected program using the Start/Stop
button
. After the time has elapsed, the appliance sets itself to warming provided
that the Start/Stop button has not been pressed.
Meal cooking
The time always depends on the ingredient with the longest cooking time (e.g. meat:
40 min, potatoes or vegetables: 10 min). Brown the meat (e.g. a roulade) using the
Brown setting, then infuse with water. Close the lid and the valve and cook using the
Meat setting (30 min). When the program has finished, vent and open lid. Put the
insert carrier and the perforated insert into the pot and put the vegetables or the
potatoes into the insert. Press the Vegetables and Start/Stop buttons. After the timer
has elapsed, the device will automatically switch to Heat or the cooking process can
be stopped by pressing the Start/Stop button.
The pot should never be more than 75% full of meat, bones,
soup vegetables etc. in order to prevent overflowing!
In order to reduce cooking time, use hot water from the tap.
Once the cooking time has elapsed, open the valve with a wooden spoon.
The escaping steam is extremely hot! During any cooking
procedure, do not open the lid until after all of the steam has left
the device!