13
Instructions
Sun canopy
Press the two front hood bows together 22 to adjust the hood. Adjusting the
hood can be ef-fected silently. By taking off the rear hood section 23, the hood
can be converted into a sun canopy by means of a zip fastener. Good
ventilation of the hood is important. To prevent heat from accumulating inside,
we recommend to open the two zip fasteners 20 and to fold up the hood flap.
As an additional protection, the sun visor 21 can be pulled out.
Lock-type-swivel wheels (only S)
Turn the cap
10
so that the red point is visible to pre-select the straight-line
motion mode, which will be activated the moment the wheels point in forward
direction. Turn the cap
10
so that the green point is visible to release the
swivel lock. To remove the wheel, release the push-button in the centre of the
cap
10
and pull the wheel off the holding device. To assemble the wheel,
insert the fastening pin in the holding device, and depress the push-button
inside the cap, which is indicated by a click sound.
Adjustable suspension system
By turning the selector
11
, a "hard" or "soft" position can be selected for
suspension.
Automatic lock for upper section
Place the stroller unit upon the chassis in a way that the two lateral bows
engage in the respective slots
18
on each side. Then push the unit right up to
the stop. The catching pins on both sides engage automatically, which is indi-
cated each time by a click sound.
WARNING!
By pulling the upper section
horizontally, check before use whether it is fixed correctly! If the red safety
point can still be seen, the upper-section lock has not yet completely closed!
Pull the green locking lever downwards until it snaps into place to open the
lock. Then remove the upper section. The stroller unit can be reversed at that.
Adjusting the footrest
First, press the two buttons
14
, located at the right and left side
respectively, to fold the footrest down. Then raise the footrest to the
required position. A number of settings up to the horizontal position can be
selected.To prolong the footrest, press the two buttons
15
, and pull it out.
WARNING!
In case the carrycot is attached to the frame, the footrest
should always be in horizontal position, as an additional protection
preventing it from slipping out.
Adjusting the backrest
By lifting the back clip
12
at the rear, the backrest can be adjusted from sit-
ting to reclining position in close steps.
WARNING!
When adjusting the
backrest, take care that no movable parts jam the baby’s limbs, or fingers, etc.
Finally, make sure the backrest has reengaged properly.