CombiSteel 7178.0090 Benutzerhandbuch

Typ
Benutzerhandbuch

Dieses Handbuch ist auch geeignet für

User and Maintenance
Instructions
Fryer
(Electric)
Handleiding Voor
Bediening En Onderhoud
Frituur
(Elektrisch)
Betriebs- und
Wartungsanleitung
Friteuse
(Elektrisch)
Manuel d’Utilisation et de
Maintenance
Friteuse
(Électrique)
2
Table of Contents / Inhoudsopgave /
Inhaltsverzeichnis / Table des Matières
I. ENGLISH ………………………………………………………………. 3
A. Description
B. Products
C. Mounting Instructions
D. Operator Instructions and Attention Points
E. Figures
F. Product Drawings
G. Electrical Connection Drawing
II. NEDERLANS ………………………………………………………… 24
A. Beschrijving
B. Producten
C. Montage-Instructies
D. Instructies van de bediener en aandachtspunten
E. Figuur
F. Producttekeningen
G. Elektrische Aansluittekeningen
III. DEUTSCH …………………………………………………………….. 45
A. Beschreibung
B. Produkte
C. Installationsanleitung
D. Benutzerhinweise und zu Beachtende Punkte
E. Abbildung
F. Produktzeichnungen
G. Elektrische Anschlusszeichnung
IV. FRANÇAIS …………………………………………………………… 66
A. Explications
B. Des Produits
C. Instructions de Montage
D. Instructions a L’utilisateur et Points a Considérer
E. Les Figures
F. Dessins des Produits
G. Dessin de connexion électrique
3
User and Maintenance
Instructions
Fryer (Electric)
4
A. DESCRIPTION
Our dear customer,
Your preferred COMBISTEEL is nature and technology friendly. We thank you for your choice.
COMBISTEEL has been produced with the understanding of "Total Quality" in modern
production facilities.
Important Safety Information
Carefully read this guide and keep it for future review.
WARNING: Installation of the devices must be done by an authorized service person.
WARNING: Equipment must be grounded.
Indicates that there is a risk of personal injury or property damage.
Explosion / fire hazard
Mounting, electrical connection and maintenance works of the device should be
performed by a specialist authorized in this subject and in accordance with the instructions
of the manufacturer company.
Electrical connection of the device should be arranged according to the tables and
electrical diagram given in this manual.
Manufacturer Company accepts no responsibility for the final damages that are caused by
any procedure not conforming to the instruction manual, or maintenance or technical
interventions that are not performed by authorized people.
5
B. PRODUCTS
C. MOUNTING INSTRUCTION
Placement
Installation and adjustment of the device should be carried out by experienced technical
staff.
In order to prevent smell and fume formation, place the device beneath an exhaust hood
being capable of enough ventilation.
Place the device at a place min. 10cm away from the side or back wall to prevent excessive
temperature rises.
Device should be placed on a flat surface by suitably balancing on the four adjustable
legs. (Figure A)
Remove the nylon protection cover on the device. If there are any adhesive residues left
on the surface, clean with a suitable solvent.
Never leave flammable material near the device.
CODE
DESCRIPTION
SERIE
7178.0088
Electric fryer, tabletop model, 10 litres
600
7178.0090
Electric fryer, tabletop model, 10 litres
600
7178.0095
Electric fryer, tabletop model, 2x10 litres
600
7178.0520
Electric fryer on closed cabinet, 18 litres
700
7178.0522
Electric fryer on closed cabinet, 10 litres
700
7178.0525
Electric fryer on closed cabinet, 2x18 litres
700
7178.0527
Electric fryer on closed cabinet, 2x10 litres
700
7178.0285
Electric fryer, tabletop model, 10 litres
700-S
7178.0290
Electric fryer, tabletop model, 2x10 litres
700-S
7178.3055
Electric fryer on closed cabinet, 22 litres
900
7178.3060
Electric fryer on closed cabinet, 2x22 litres
900
6
Electrical Connection
Connect the device to the electrical installation according to the electrical standards of
the relevant country.
Feed the device with suitable network voltage written on the information plate.
Connect to the electrical installation over a suitable automatic fuse. Fix the said fuse on a
place that is easily accessible in case of a danger.
The cable connecting the device to the electrical installation should be at least type H05
RNF.
Before connecting the electrical inlet cable to the electrical inlet clamp, connect the cable
on the device by passing it through the inlet coupling and then tighten the coupling cover
in a manner that does not allow cable return.
Voltage tolerance should not exceed ± 10%.
Electrical inlet clamp can be seen by disassembling front panel.
Electrical inlet is indicated with a label on the device.
If the device will be used in a commercial kitchen, apply a correct grounding system.
Here, consider DIN VDE D100 Article 540.
The device must be grounded. Grounding point is marked with " ".
D. OPERATOR INSTRUCTIONS AND ATTENTION POINTS
WARNINGS
Pay attention not to contact hot surfaces of the device!
Device is designed for professional use and must be used only by person who are trained
for this intention.
Device is intended for cooking, do not use for another purpose.
If there is any failure in the device, disconnect electrical power by deactivating the main
switch.
Commission only authorized services for maintenance and use genuine spare parts.
Before starting to use the device, carefully clean the surfaces especially those to be in
contact with foods.
During first operation, device will emit fume and smell for a short period. This fume and
smell is the result of the insulation material and the substances such as oil, etc. on the
metal sheet surfaces. This is not dangerous and will disappear by itself.
Do not operate the device without oil or under minimum level (Figure B)
Before filling oil, close discharge valve.
Fill oil up to the maximum level prior to put into operation.
Replace frying oil with certain intervals before its properties are lost. Thus, you prevent
also burned and carbonized residue accumulation on heater and chamber surface.
Refill oil when it descends to minimum level. Minimum and maximum oil levels are
marked on oil container. (Figure B)
Do not place foods without draining their water, or foods with solid ice parts.
Rise up the movable headed heater group (4) through its lever to allow cleaning.
Afterwards, you should side-shift support latch (5) to take down it again. (Figure C)
Do not use fat. Do not use without oil. Do not open valve when oil is not.
7
MAINTENANCE
Do not perform maintenance when the device is hot and loaded with electrical power.
Before it cools down completely, wipe the device with a cloth immersed in warm soapy
water.
Firstly fill in water and boil to clean oil chamber. This will help cleaning the concrete and
sticky oils easily. Discharge assembly will also be cleaned.
Do not use cleaning substances and tools that may cause scratches on device surface.
If required, use chemical cleaners.
Do not clean the device with water or vapour pressure. Otherwise, you may cause
electrical installation failure.
If the device will not be used for a long period, coat the surfaces with a thin layer of
Vaseline.
In case of any dangerous condition with the device, notify to the authorized service. Never
let unauthorized people to interfere in the device.
START-UP (Figure D)
Turn switch a "6" to position "1".
Adjust thermostat "7" to desired temperature.
When signal light "8" is off, the oil reaches to desired temperature. You can now start to
cook.
TURNING OFF (Figure D)
Turn thermostat "6" to position "0".
Turn switch a "7" to position "0".
IMPORTANT
Thermostat is limited with 230º C; if it reaches to this temperature for any reason, the circuit
will be cut off. In order to reactivate, wait for oil to cool. Then, by opening the cabinet cover,
push down the red button seen on the installation metal sheet present on the lower part of the
front panel with a thin screwdriver until a contact sound is emitted. If this limit switch activates
the circuit again after the oil is heated, apply to the authorized service.
8
Compatibility Information
This device is designed and manufactured in accordance with the following directives and
standards
marking directive, 93/68/EEC
TS EN 60335-1:2012/AC
TS EN 60335-2-37:2002
Related to CE Directive(s):
2014/35/EU (Low Voltage)
Limitation of Liability: All technical information contained in this manual, operating
instructions, operation and maintenance of the device, contains the latest information on your
device. The manufacturer accepts no responsibility for damage or injury which may result
from failure to follow the instructions in this manual, use outside of the intended use,
unauthorized repair, unauthorized modifications to the device, or use of spare parts not
approved by the manufacturer.
9
E. FIGURES
Figure A
Figure B
10
Figure C
Figure D
11
F. PRODUCT DRAWINGS
Product
Depth
(D)
Height
(H)
Electrical
Inlet
Power
Cable
Sections
Weight
Volume
Capacity
7178.0088
600 mm
300 mm
230V AC
1N PE
3,5 kW
3x2.5
H05RNF
17 kg
0.14
10 lt
7178.0090
600 mm
300 mm
400V AC
3N PE
7,5 kW
5x2.5
H05RNF
20 kg
0.18
10 lt
7178.0095
600 mm
300 mm
400V AC
3N PE
15 kW
5x4
H05RNF
34 kg
0.28
2x10 lt
7178.0520
700 mm
900 mm
400V AC
3N PE
14 kW
5x4
H05RNF
53 kg
0.44
18 lt
7178.0522
700 mm
900 mm
400V AC
3N PE
7,5 kW
5x2.5
H05RNF
53 kg
0.44
10 lt
7178.0525
700 mm
900 mm
400V AC
3N PE
28 kW
5x6
H05RNF
83 kg
0.90
2x18 lt
7178.0527
700 mm
900 mm
400V AC
3N PE
15 kW
5x4
H05RNF
81 kg
0.84
2x10 lt
7178.0285
700 mm
300 mm
400V AC
3N PE
7,5 kW
5x2.5
H05RNF
28 kg
0.21
10 lt
7178.0290
700 mm
300 mm
400V AC
3N PE
15 kW
5x4
H05RNF
47 kg
0.36
2x10 lt
7178.3055
900 mm
900 mm
400V AC
3N PE
18 kW
5x4
H05RNF
64 kg
0.56
22 lt
7178.3060
900 mm
900 mm
400V AC
3N PE
36 kW
5x6
H05RNF
94 kg
1.05
2x22 lt
12
7178.0088
7178.0090
13
7178.0095
7178.0520
14
7178.0522
7178.0525
15
7178.0527
7178.0285
16
7178.0290
7178.3055
17
7178.3060
18
G.ELECTRICAL CONNECTION DRAWING
7178.0088
19
7178.0090 / 7178.0520 / 7178.0522 / 7178.0285
20
7178.0095 / 7178.0525 / 7178.0527 / 7178.0290
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58
  • Page 59 59
  • Page 60 60
  • Page 61 61
  • Page 62 62
  • Page 63 63
  • Page 64 64
  • Page 65 65
  • Page 66 66
  • Page 67 67
  • Page 68 68
  • Page 69 69
  • Page 70 70
  • Page 71 71
  • Page 72 72
  • Page 73 73
  • Page 74 74
  • Page 75 75
  • Page 76 76
  • Page 77 77
  • Page 78 78
  • Page 79 79
  • Page 80 80
  • Page 81 81
  • Page 82 82
  • Page 83 83
  • Page 84 84
  • Page 85 85
  • Page 86 86
  • Page 87 87

CombiSteel 7178.0090 Benutzerhandbuch

Typ
Benutzerhandbuch
Dieses Handbuch ist auch geeignet für